American-electric-lighting AVL, ASA, VMR, VLR, PES & PEM User Manual download pdf

Installation:

Attach tenon slipfitter to luminaire by guiding it over the fitter base, being careful to align it with the roll pins on the bottom of the fitter base

Thread the center bolt into the slipfitter and tighten from topside of splice compartment. Feed supply wires from the pole through tenon

slipfitter into splice compartment. Slide fixture with slipfitter attached onto the pole tenon. Orient the fixture for appropriate light throw

(if required). Alternately tighten 3/8” set bolts until fixture is in desired position and all set bolts are securely tightened. Make wire con-

nections in splice compartment being sure to observe proper polarity. Tuck wires neatly into splice compartment. Place splice compart-

ment cover onto unit and secure with screw provided. Recheck all bolts and hardware to ensure it is properly secured.

Wires should not be energized during installation and maintenance. Options are to be installed in the field. DO NOT alter fittings when

mounting the fixtures. Recheck all connections and bolts to insure they will not loosen due to vibration.

Square Pole Fitter:

S3 For 2-3/8” O.D. Tenon

S7 For 2-7/8” O.D. Tenon

Round Pole Fitter:

P3 For 2-3/8” O.D. Tenon

P7 For 2-7/8” O.D. Tenon

Dimensions and specifications on this page are

based on the most current available data and are

subject to change without notice.

INSTALLATION INSTRUCTIONS

PES/PEM, VLR/VMR, ASA, AVL SERIES MOUNTING OPTIONS

(S3, S7, P3 P7 OPTIONS)

American Electric Lighting, a division of Acuity Brands Lighting, Granville, OH

DRAWING NO. A72261 REV B (FRONT)

PART NUMBER 057-71-72261

WARNING

1 2 3 4 5 6

WARNING 2

Summary of Contents

Page 1

Installation:Attach tenon slipfitter to luminaire by guiding it over the fitter base, being careful to align it with the roll pins on the bottom of th

Page 2 - WARNING

Installation: Reference the mounting plate detail below, secure mounting plate to the wall or wood pole with two (2) 5/8” fasteners (supplied by other

Page 3

Installation: Reference the mounting plate detail below, secure mounting plate to the wall with four (4) ½” fasteners (supplied by others). Start to t

Page 4

Installation: inside arm. Again check to see “TOP” label is on top of arm and towards fixture end of the arm. Place remaining gasket over t hreaded

Page 5

Installation: Remove the top plate of the wiring compartment. Make wiring connections. Secure by slipping the fixture, internal wedge end first, int

Page 6

Installation: (1) Remove optical assembly and set aside. 2) Pull input wires into housing. 3) Place fitter (3” wide x 5 ¼” tall x 5.3” deep) A a

Comments to this Manuals

No comments

American-electric-lighting AVL, ASA, VMR, VLR, PES & PEM User Manual

Browse online or download User Manual for Lighting American-electric-lighting AVL, ASA, VMR, VLR, PES & PEM. American Electric Lighting AVL, ASA, VMR, VLR, PES & PEM User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting American-electric-lighting AVL, ASA, VMR, VLR, PES & PEM